Antares ATR-1 Guide de l'utilisateur télécharger pdf (Page 26)

Antares Auto-Tune

You will see the plug-in’s input meter become active as you raise

the mixer input channel’s aux send.

Set the plug-in input/output signal levels as you would with any

effect, so the meter reaches its upper-most range every so often

(always trust your ears first). This can be accomplished from the

console or GUI.

Pre-Fader and Post-Fader Auxiliary Sends

Normally, effect sends are post-fader, so the signal sent to the

effect follows the program level in the mix. Occasionally you

may wish to feed an effect from a pre-fader source so that the

signal level from the aux control is independent of the channel

fader position. Aux sends are selectable pre- or post-fader

globally (all Aux 1’s for instance) from the Mix Options screen in

the Setup window, or individually on a channel-by-channel basis

either from the channel strip or the Fat Channel.

In the channel strip, Alt-click the Aux Send level

indicator to toggle between pre-and post-fader operation.

Post-fader is indicated by a red bar, pre-fader is indicated

by a yellow bar.

In the Fat Channel,

clicking on the small

indicators below the

Aux knobs toggles

between pre- and post-

fader operation. Yellow

indicates pre-fader,

post-fader is indicated

by the background

color.

Fat Channel

Channel Strip

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Antares ATR-1 Guide de l'utilisateur Page 26